Your Remington 700 short action needs a few small modifications in order to work with the Gen II R5 stock, while a milling
machine would be best for the job, you can achieve satisfactory results with a dremel type tool by just taking your time and
being careful.
The front end of the magazine well needs a small radius cut to allow for bullet tip clearance, just use the
cut out in the bottom of the action sleeve as your guide as to how much material to remove.
The rear of the magazine well also needs to have the projection removed as per the photo
Fair out the feed ramp after taking the radius cut, only a small amount should be needed
Competition Machine 3121 E. La Palma Ave. Unit Q Anaheim, CA 92806
